Quote:
Originally Posted by Father Mike
I recently bought a replacement endpin from Stewart Macdonald that is supposed to fit into a jack strap hole. Imagine my surprise to find out that it is too big to fit into the hole.
|
Make sure you take the anchoring screw all the way off before trying to insert the pin. Also, if that works,
do not over tighten the screw when anchoring the pin. The pin sleeve will snap in a minute if you over tighten. BTDT!
Quote:
Originally Posted by Father Mike
|
My 2015 412-R (no e!
) came with one of these. It is a very nifty little device that helped make the K&K install a breeze.
I'd say it is significantly better than the Stew-Mac replacement end pin, and if I ever need another one of these this is the one I will buy.